This could be what you're looking for as far as plug-n-play goes.

 

Hi there sorry for the delay I think I might have been talking to you in comments on YouTube at one point before that sounds like it could work I really dont want to cut any wires what would it cost to have one shipped to Ontario?

and suggestions on running my power wire it will be going to from the start battery to an agm I plan to install in the trunk I'm only pushing 1600watts probably overkill to add a that agm

Sent from my SM-N960W using Tapatalk

 

The cost of shipping to Ontario should be $10 USPS.At least the last few I've shipped up there were anyway.As far as the power wire goes,I ran mine underneath the vehicle(0awg) and up through the large grommet on the driver side rear.

 

Oh ok not as bad as I was thinking it probably weighs next to nothing definitely have an interest will need to wait a bit before I place an order for that I'm still haveing issues desiding what way I want to go dual battery or just run a wire and call it a day is that grommet easy to get to? And should I run 0 gage my amp hads 4 gage inputs for power and ground

I greatly appreciate your time and help by the way any help will be greatly appreciated as my nox is new to me and just want it done right with out paying the shop in town 1000 just to run my wires

Sent from my SM-N960W using Tapatalk

 

Here is a thread about the audio build I just finished in a Terrain.There is a ton of useful information in it that will help you.I would definitely run 0awg if I was you to a distribution block.You'll find in the thread a picture of the rear grommet and also how I attached the power wire and fuse to the battery.

https://www.terrainforum.net/32-aud...et/32-audio-video-nav/25455-2011-terrain-aftermarket-audio-system-finished.html

 

Thanks man I'll definitely have a look I'll probably send you a message about that harness in a couple weeks once I figured everything out thanks again

Sent from my SM-N960W using Tapatalk

 

That's crazy man just had a look wasn't expecting that set up looks bad ass I dont have the tools for the bulid or I'd do something similar but that spot where you have your power wire come in do you think it's big enough for a battery that would be a good spot to hide one if it fits

Really aiming for a second battery as I want to add a light bar and stuff like that so I'm thinking 2 batteries with a isolator will do the trick

Also one more question are you running the stock alternator with the big three or just stock

Sent from my SM-N960W using Tapatalk

 

I'm not sure you'd fit another battery under there.I know a guy here called Banddirector mounted his amplifier under there.I did not run the big three just stock.The system as of now is putting out 1900w RMS and it doesn't even budge the electrical system.