GMC Terrain, Equinox, and SRX Forum banner
1 - 1 of 1 Posts

·
Registered
Joined
·
1,153 Posts
mIX said:
Removing the headrests was required in order to get our car seat to fit against the back properly. So there is a legit reason to do it.

I just used two small allen wrenches to push into the holes and pop them out. It would have been easier with a second person to pull up on the headrest. ;)
I found that a second person is an absolute must to remove mine since the tiny holes in the mount attached to the seat back are almost recessed below the leather..
 
1 - 1 of 1 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top