[RAW2u]

Link to slide show with installation of the Jet MAF sensor
http://www.flickr.com//photos/[email protected]/sets/72157627586201209/show/

Increases your airflow by up to 45%
Built from OEM sensor loaded with specialized programming
Takes only minutes to install, no drilling or cutting
1-year warranty

The Jet Performance Power-Flow Mass Air Sensor gives your engine the airflow it craves and the performance it was truly made to deliver. With the Power-Flow MAS, expect up to a 45% increase in airflow, immediate gains in torque and horsepower, and an improvement in your gas mileage.

Jet builds the Power-Flow from the OEM air sensor, and flashes a specialized program to it. The re-tuned sensor communicates with the engine's computer, providing gains in power and torque. Because it is essentially a stock sensor, the Power-Flow works perfectly with the stock electronics and other systems in your vehicle. The Power-Flow works best with other air system modifications and performance chips.

The essentially OEM Power-Flow MAF fits perfectly in your vehicle. Installation takes under 15 minutes, as it simply clamps or bolts on in place of your old sensor. In no time you'll have a vastly more powerful ride!

 

[gtpprix]

Giant scam

 

[RIT333]

Giant scam

Chris - care to elaborate ? You may be right, but how do you know ?

 

[RAW2u]

Sure fill in the blanks ?

 

[Scooby24]

This is a load of BS. The MAF is providing input on airflow via a voltage signal. The only way a sensor can make more power is if they alter the calibration of the sensor to trick the computer into believing there is more or less air and adjusting fuel based on that. In normal driving this is going to be pointless as closed loop fueling is going to rely on the o2 sensor to hit a target AFR and altering the MAF signal is going to have little impact until the vehicle goes into open loop fueling in higher throttle/load conditions.

This is an unsafe purchase and should not be considered by ANYONE.