[leadpathfinder]

Hi I am installing a parking sensor in the front bumper and wanted to know how to route wires from the front bumper to the inside of the car basically below the steering wheel.

Is there any existing cable route that I can use.

I want to avoid using the emergency brake path.

Cheers

Pathfinder

 

[gar187er]

you should be to follow an existing path whether its following the brake wiring, misc electrical wiring, etc, you should be able to find a grommet fairly easy to access and either poke a hole through it, or pull it out and insert your new wire into the bundle....

previous cars/trucks ive worked on when installing car stereos/subs, there was always a empty grommet from where the cluth would feed through, but since these are now all autos, not gonna have luck there, but your wire will be small enough to fit anywhere you have access to.

 

[leadpathfinder]

Thanks I want to take the wiring through to below the Steering Dash. I have a Chevy Equinox 2010.

Any suggestions on how to do this most easily.

Cheers

Pathfinder