Craftsman screwdrivers?
I've only ever had to replace a headlight two times. Once on my '67 Camaro and once on the wife's old '78 Trans Am Special Edition. Both were easy peasy... Remove exterior grill piece (a couple of phillips screws), remove retaining bezel (more phillips screws), pull out bulb, disconnect wiring from back of bulb, reverse process to install. No disassembling half the front end of the vehicle, and it was a one peson job since the pieces weighed next to nothing.
Still have the Camaro (see my signature below). The T/A was three cars ago for the wife.
I've only ever had to replace a headlight two times. Once on my '67 Camaro and once on the wife's old '78 Trans Am Special Edition. Both were easy peasy... Remove exterior grill piece (a couple of phillips screws), remove retaining bezel (more phillips screws), pull out bulb, disconnect wiring from back of bulb, reverse process to install. No disassembling half the front end of the vehicle, and it was a one peson job since the pieces weighed next to nothing.
Still have the Camaro (see my signature below). The T/A was three cars ago for the wife.
