GMC Terrain, Equinox, and SRX Forum banner

1 - 7 of 7 Posts

·
Registered
Joined
·
244 Posts
Discussion Starter #1
So for Bank 2, there is an aluminum bracket, that connects to engine then to engine mount. Can this be removed without securing engine?
I am trying to replace the two Actuators and Sensors, and they all sit behind it. I might be able to get a open end wrench on them, but it does not look like I have enough clearance to slide them out


2010 Terrain 3.0 FWD
 

·
Registered
Joined
·
34 Posts
Your going to have to secure the motor just put a jack under it whenever you take it off a motor mount or it will shift and probably break those connectors yea just pop off that mount it should give you plenty of room.
 

·
Registered
Joined
·
2,137 Posts
I checked my 2014 repair manual and the 3.6L is different.
No aluminium bracket but it does have a exhaust heat shield that must be removed.
 

·
Registered
Joined
·
2,137 Posts
That's your front motor mount, looks slightly different than the 3.6L.
Probably best to support the bottom of the motor with a jack and remove it.
I would also get the air cleaner box out of the way so you have room to work.
 
1 - 7 of 7 Posts
Top