GMC Terrain, Equinox, and SRX Forum banner

1 - 7 of 7 Posts

·
Registered
Joined
·
3,562 Posts
Wow! Coming off already on a 2017?!?!??

My 2011 is still good! Helm Manual says this thing is held on with (4) nuts and some tape. It says you have to remove the lift gate panel on the inside (remove a rectangular plastic cap, revealing a single Phillips screw, then a trim panel removal tool to pry the panel off). Then the (4) nuts and tape holding the appliqué on.

Sounds like you just need to remove and replace the tape?
 

·
Registered
Joined
·
10,112 Posts
Under warranty still ?
 

·
Registered
Joined
·
44 Posts
stick some 3m double sided body tape behind it. That stuff is crazy strong. You'll be able to pick the vehicle up by that trim piece
 

·
Registered
Joined
·
30 Posts
I had to replace the gasket for mine. Couldn't buy just it so I used a roll of "D" shaped weather stripping from Lowe's. At least that's what I recall it was, in the same section at least. Had sticky on one side so I put it on the trim, bolted it back. Water tight and keeps it from rubbing the paint off, which leads to rust.
 
1 - 7 of 7 Posts
Top