Transfer Case Failure - Page 2 - TerrainForum.net: GMC Terrain Forum
 7Likes
Reply
 
LinkBack Thread Tools
post #11 of 20 (permalink) Old 10-06-2019, 12:08 PM Thread Starter
Sr. Member
 
afterhoursfab's Avatar
 
Join Date: Aug 2013
Posts: 259
Quote:
Originally Posted by Colt Hero View Post
So what are the price points for fixing something like this - used, junk yard parts, versus new? And you’re going to do the work yourself (I presume), but what would an independent shop charge (never mind the dealer)...?
The dealer wanted $950 for a new one but it is not available due to the current strike. Aftermarket rebuild was $750 with the same 3 year warranty and a weeks wait so I went with that. Labor guide says 4.8hrs so an independent shop around here would charge around $500, dealer probably $6-700.

We live in NJ so AWD isn't a necessity but great to have in the winter. And my wife works on the other side of a small mountain so shes up and down a steep grade every day.

2013 SLT-2 6cyl AWD - Current Daily
2011 SLE-1 4cyl FWD - Drove for 2 years, sold 6/17
2013 Denali 6cyl AWD Fire Damage - Parted out
2012 SLE-1 4cyl AWD Lease - Turned back in 3/16
2014 SLT-2 6cyl FWD Rollover - Parted out
afterhoursfab is offline  
Sponsored Links
Advertisement
 
post #12 of 20 (permalink) Old 10-06-2019, 12:13 PM Thread Starter
Sr. Member
 
afterhoursfab's Avatar
 
Join Date: Aug 2013
Posts: 259
Quote:
Originally Posted by rednox301 View Post
Bummer, at least you didn't have to waste a lot of time diagnosing the problem.
Those 301 horses were hard on the transfer case.
Haven't seen you on the forum in a while, always liked your posts.
Ya I believe it's similar to other problematic awd trucks with a lot of power like the Trailblazer SS and Silverado SS and it just can't handle the power. Why else would the bearing explode?

I don't get on here much, just too busy. I enjoy writing how-tos tho and I've been an admin on S10Forum for at least 15 years. Back in the day it was very busy, now its dead.

2013 SLT-2 6cyl AWD - Current Daily
2011 SLE-1 4cyl FWD - Drove for 2 years, sold 6/17
2013 Denali 6cyl AWD Fire Damage - Parted out
2012 SLE-1 4cyl AWD Lease - Turned back in 3/16
2014 SLT-2 6cyl FWD Rollover - Parted out
afterhoursfab is offline  
post #13 of 20 (permalink) Old 10-06-2019, 12:15 PM Thread Starter
Sr. Member
 
afterhoursfab's Avatar
 
Join Date: Aug 2013
Posts: 259
Quote:
Originally Posted by regnox1113 View Post
I’ve had to replace the rear output shaft seal on the transfer case twice. Each one lasted around 20k miles. Both were under warranty (had an extended one). They wouldn’t replace the transfer case. We’ll see if the seal goes again. Not sure if it’s any kind of indicator on the durability of this particular transfer case. 54k on the Nox now.
Strange, maybe the rear bearing is a little sloppy? Mine was dry as a bone at the seals..

2013 SLT-2 6cyl AWD - Current Daily
2011 SLE-1 4cyl FWD - Drove for 2 years, sold 6/17
2013 Denali 6cyl AWD Fire Damage - Parted out
2012 SLE-1 4cyl AWD Lease - Turned back in 3/16
2014 SLT-2 6cyl FWD Rollover - Parted out
afterhoursfab is offline  
Sponsored Links
Advertisement
 
post #14 of 20 (permalink) Old 10-06-2019, 07:03 PM Thread Starter
Sr. Member
 
afterhoursfab's Avatar
 
Join Date: Aug 2013
Posts: 259
Here is the new transfer case. Also required is synthetic 75W90 gear oil, new sealing o-ring 19132943, and Dexron VI transmission fluid equal to however much came out previously. I opted to completely drain the trans and then it sat for 2 weeks and the converter drained further so I needed 6 quarts total. If you don't want to change the fluid then you can drain about 1 qt out and it should be low enough that you don't take a bath when the t-case is removed.
Attached Images
File Type: jpg 20191006_113645_1570399188378.jpg (453.8 KB, 19 views)
ThreeNox likes this.

2013 SLT-2 6cyl AWD - Current Daily
2011 SLE-1 4cyl FWD - Drove for 2 years, sold 6/17
2013 Denali 6cyl AWD Fire Damage - Parted out
2012 SLE-1 4cyl AWD Lease - Turned back in 3/16
2014 SLT-2 6cyl FWD Rollover - Parted out
afterhoursfab is offline  
post #15 of 20 (permalink) Old 10-06-2019, 07:05 PM Thread Starter
Sr. Member
 
afterhoursfab's Avatar
 
Join Date: Aug 2013
Posts: 259
Here are all the parts that were removed to access the transfer case for my V6. Not a terrible job but depending on mileage, age, and region you may have problems with the exhaust coming apart.
Attached Images
File Type: jpg 20191006_114606_1570399456202.jpg (540.5 KB, 20 views)
bigb12359 likes this.

2013 SLT-2 6cyl AWD - Current Daily
2011 SLE-1 4cyl FWD - Drove for 2 years, sold 6/17
2013 Denali 6cyl AWD Fire Damage - Parted out
2012 SLE-1 4cyl AWD Lease - Turned back in 3/16
2014 SLT-2 6cyl FWD Rollover - Parted out
afterhoursfab is offline  
post #16 of 20 (permalink) Old 10-06-2019, 07:10 PM Thread Starter
Sr. Member
 
afterhoursfab's Avatar
 
Join Date: Aug 2013
Posts: 259
Tech tip: if you look closely you can see I made a couple alignment dowels out of 12mm x 75mm bolts with the heads cut off. This will help align the transfer case and keep the o-ring from getting pinched or cut and causing a fluid leak.

In the 2nd pic you can see one of the exhaust studs is shorter than the other. I had to heat these nuts with a torch to get them off and then the one snapped the stud when it was halfway off. Luckily there are just enough threads left for the nut to hold.

Also 2 of the tiny 5mm x 15mm bolts that hold the heat shield on the transfer case broke off inside the aluminum so I had to replace those with a dab of antiseize for good measure.
Attached Images
File Type: jpg 20191006_113512_1570399557756.jpg (471.2 KB, 21 views)
File Type: jpg 20191006_124122_1570399567905.jpg (448.9 KB, 19 views)
bigb12359 likes this.

2013 SLT-2 6cyl AWD - Current Daily
2011 SLE-1 4cyl FWD - Drove for 2 years, sold 6/17
2013 Denali 6cyl AWD Fire Damage - Parted out
2012 SLE-1 4cyl AWD Lease - Turned back in 3/16
2014 SLT-2 6cyl FWD Rollover - Parted out
afterhoursfab is offline  
post #17 of 20 (permalink) Old 10-16-2019, 01:07 PM
Newbie
 
Join Date: Oct 2019
Posts: 2
Hello kind sirs...I have a question. My 2013 Equinox needs a new transfer case and everyone I tell that to says it shouldn't need one at 53K miles. The dealer wants $3,000 to fix it and I'm disabled on a fixed income and barely have $3 to spare. Is this a normal mileage for them to fail or should I fight with GM about it? I bought it used and of course, my warranty expired in December of 18. I still owe about 12k on it...I know I know...there was nothing I could do at the time, I needed a car so please don't judge :-)

Any advice would be much appreciated!
Debbie
DebbieR is offline  
post #18 of 20 (permalink) Old 10-16-2019, 10:19 PM
Theta GOD!
 
Join Date: Jan 2010
Posts: 9,648
Too early to happen, but stuff happens. It is worth complaining to GM, but they may only cut some slack, it will still cost a ton. You can try an independent shop, and it will be cheaper.

2018 Equinox LT1 1.5 L 4 cyl, AWD, S/R Cajun Red Tintcoat/Black

2010 Equinox LTZ 2.4 L 4 cyl, FWD, S/R Cardinal Red/Black
RIT333 is offline  
post #19 of 20 (permalink) Old 10-17-2019, 11:02 AM
Newbie
 
Join Date: Oct 2019
Posts: 2
Thank you so much!! The 'too early to happen' seems to be a running answer from all around. The dealer actually put in paperwork to get some help from GM...it was declined. But they gave me the contact info for me to complain about it myself. Which I intend to do.

Thanks again for your reply...have a great day!
Debbie
DebbieR is offline  
post #20 of 20 (permalink) Old 10-17-2019, 05:12 PM Thread Starter
Sr. Member
 
afterhoursfab's Avatar
 
Join Date: Aug 2013
Posts: 259
Anything failing under 100k is too soon in my opinion. Yours went out at 56k, mine at 70k. Get recommendations from friends for an independant shop, it should be far cheaper than the dealership. Tip: don't tell the shop what the dealership wanted to charge you! Still expect to spend at least $2000 tho 😕

2013 SLT-2 6cyl AWD - Current Daily
2011 SLE-1 4cyl FWD - Drove for 2 years, sold 6/17
2013 Denali 6cyl AWD Fire Damage - Parted out
2012 SLE-1 4cyl AWD Lease - Turned back in 3/16
2014 SLT-2 6cyl FWD Rollover - Parted out
afterhoursfab is offline  
Reply

Quick Reply
Message:
Options

Register Now



In order to be able to post messages on the TerrainForum.net: GMC Terrain Forum forums, you must first register.
Please enter your desired user name, your email address and other required details in the form below.

User Name:
Password
Please enter a password for your user account. Note that passwords are case-sensitive.

Password:


Confirm Password:
Email Address
Please enter a valid email address for yourself.

Email Address:
OR

Log-in









Human Verification

In order to verify that you are a human and not a spam bot, please enter the answer into the following box below based on the instructions contained in the graphic.



Thread Tools
Show Printable Version Show Printable Version
Email this Page Email this Page



Posting Rules  
You may post new threads
You may post replies
You may not post attachments
You may not edit your posts

BB code is On
Smilies are On
[IMG] code is On
HTML code is Off
Trackbacks are On
Pingbacks are On
Refbacks are On

 
For the best viewing experience please update your browser to Google Chrome